Insteon Device Setup

From Cinemar Wiki
Jump to: navigation, search

Insteon PLC

Setup two way communication with PLC and Switchlinc
1. Add the switch to the plc database by pressing the set button on the plc for 10 sec and then pressing the set button on the device for three sec.
2. Add the plc to the Switchlincs database by pressing the paddle up for 10 sec and then pressing the set button on the plc for 10 sec.

Setup two way communication with PLC and Keypadlinc
1. Add the switch to the plc database by pressing the set button on the plc for 10 sec and then pressing the set button on the device for three sec.
2. Add the plc to the Keypadlincs database by pressing the On button for 10 sec and then pressing the set button on the plc for 10 sec.


Link appliance link to plc
1. Add the appliance link to the plc database by pressing the set button on the plc for 10 sec and then pressing the set button on the appliance link for 3 sec.

Note: In order for you to receive status messages from an appliance link it must be linked to another insteon device such as a dimmer switch.

Link appliance link to a switch
1. Add the appliance link to the switches database by pressing the paddle up on the switch for 10 sec and then pressing the set button on the appliance link for 10 sec.

Reset Switchlinc Relay
1. Press and hold the paddle up for 10 sec.
2. Press and hold the set button for 3 sec.

Reset Switchlinc Dimmer
1. Pull the set button out for 10 sec.
2. Press and hold the set button for 3 sec.